|
Parameters “AF Material Correct” (default settings)
Basic Material
| Base Material |
Sub-Material which demands to be corrected |
Color Balance
Hue / Saturation / Luminance (HLS)
This correcting will calculate after “Color Balance”,
that is why result of changing parameter “Hue” strongly depends
on Color Balance parameters.
Preserve Luminositi - Saving summary color brightness after this correcting.
Luminance  - Method of changing brightness
 Additive (+) |
Changing brightness of all pixels (dark inclusive)
by means of adding “Luminance” value.
|
 Scale(Mul) |
Changing pixels brightness by means of multiplication
on “Luminance” value.
(black pixels remain black)
|
| Post Luminance |
Order of brightness correcting:
before transformation from HLS to RGB
(correcting “L” component),
or after that (correcting of three components R,G,B).
Default is Enabled (RGB correcting)
This flag can be useful by use additive method of
changing brightness.
|
|
Brightness / Contrast
| This correcting will calculate after above mentioned, that is why its
result is strongly depended on them.
|
Advanced
Clamp Max
|
To forbid brightness of any other color components (R,G,B)
after correcting, to increase maximum value (1.0).
|
Scale Overlimit
|
If, before correcting, brightness of any other color components
(R,G,B ) increased maximum value. So, before correcting,
brightness would be normalized and after correcting general
brightness will be restored in accordance with coefficient of
decreasing during normalization.
|
|
